Installation Guide

8 9
Hardware Used
Hardware Used
Hardware Used
7. Use the shelf hole plugs (CC) to seal the empty
holes.
8. Stick the bumpers (FF) at the two corners of the
door (D) opposite the door hinges (A).
9. To power the item, either insert 3 C batteries (not
included) into each battery compartment on the bottom
of cabinet (C) or insert the adapter (KK) into the DC
jack at the bottom of cabinet (C), plugging the other end
into a nearby outlet.
Note: When the adapter (KK) is plugged in, power from
any installed batteries will be cut immediately.
Shelf Hole Plug
Bumper
Adapter
x 20
x 2
x 1
CC
FF
KK
CC
FF
7
8
9
OPERATING INSTRUCTIONS
POWER:
1.
Off mode
: Clock and night light will be OFF; clock is still operational, though it can be reset
in this mode, too.
2.
On mode:
Clock and night light are both ON.
3.
Auto mode:
The photocell at the bottom of cabinet (C) detects the brightness of the room
and displays particular settings based on motion detection.
• Daytime: The night light will be OFF, but the clock will be ON; the clock will turn OFF after 15
seconds of no motion detected.
• Nighttime: The night light and the clock will be ON. The night light will turn OFF after 180
seconds of no motion detected, and the clock will turn OFF after 15 seconds of no motion
detected.
1. Off mode 2. On mode 3. Auto mode
Bottom view of the cabinet (C)
Battery
Compartment
Battery
Compartment
DC Jack
3-way Switch
Photocell Sensor
Night Light
Motion Sensor
Battery
Compartment
Battery
Compartment
DC Jack
第 8 页 第 9 页
Lowes.com/allenandroth
Lowes.com/allenandroth
ASSEMBLY INSTRUCTIONS