Installation Guide

6 7

SURFACE-MOUNT INSTALLATION INSTRUCTIONS SURFACE-MOUNT INSTALLATION INSTRUCTIONS

5. Remove the paper from the preassembled adhesive

tape on each side mirror bracket (JJ), then carefully

attach side mirrors (B) to each side of cabinet (C).

Proceed to ASSEMBLY INSTRUCTIONS on page 9 to

complete assembly.

第 6 页第 7 页

Hardware Used

4. Attach side mirror brackets (JJ) to cabinet (C)

where shown (on both sides) with short screws (AA)

and washers (EE), then snap caps (DD) to cover the

screw heads.

Short Screw

Snap Cap

Washer

Side Mirror Bracket

x 4

Lowes.com/allenandroth

Hardware Used

3a. For drywall installations: With the assistance of

another person, install the top clips (II) by inserting the

rounded ends into the rear top slot of cabinet (C).Slide

one top clip (II) to the left and one to the right, then

secure using long screws (GG) through the top clips (II)

and directly into the wall studs.

3b. For solid wall installations: With the assistance of

another person, install the top clips (II) by inserting the

rounded ends into the rear top slot of cabinet (C) Slide

one top clip (II) to the left and one to the right, then mark

locations with a pencil. Temporarily move top clips (II)

out of position, then use a 5/16-in. drill bit (not included)

and drill a pilot hole at marked locations. Move top clips

(II) back into position and insert wall anchors (HH) into

holes, then insert long screws (GG) through top clip (II)

and into wall anchors (HH).

Top Clip

Long Screw

x 2

Wall Anchor

x 2