Instructions / Assembly

NO. 36 FOUNDATION SILL SCREED
www.cemcosteel.com
ASTM’s and Code Standards
■ ASTM A653
■ 2007 CBC
■ 2006 IBC
Project Information Contractor Information Architect Information
Name: _________________________ Name: _____________________________ Name: ____________________________
Project: _________________________ Contact: ____________________________ Contact: ___________________________
______________________________ Phn: _____________FAX: ______________ Phn: _____________FAX: ______________
CEMCO’s No. 36 Foundation Sill Screed is nailed or stapled to the sill plate provides
a straight line stucco stop. Manufactured with ½” holes, the sill screed allows for water and
moisture to weep from the exterior plaster system and away from the structure.
For more technical information about this and other
CEMCO products, contact Technical Services at
800.416.2278
Technical Services
Packaging
Size Ground (G) Steel Thickness Flange Size Wt./Mlf. Length Pcs./Bdl. Pcs./Pallet
5 1/2” 7/8” .019” 3-1/2” 407 lbs. 10’ 10 1000
Corporate Headquarters
263 N. Covina Lane
City of Industry, CA 91744
Phone: [phone] | Fax: [phone]
www.cemcosteel.com
Structural Engineering/Design
1001-A Pittsburg Antioch Hwy
Pittsburg, CA 94565
Phone: [phone] | Fax: [phone]
Technical Services
263 N. Covina Lane
City of Industry, CA 91744
Phone: [phone] | Fax: [phone]
Manufacturing Facilities
City of Industry, CA
Denver, CO
Ft. Worth, TX
Pittsburg, CA
LEED Points and Recycled Content
By using CEMCO metal lath products, your project can contribute
to earning LEED points for:
■ LEED MR 2.1 and 2.2: Construction Waste Management: Up to 2 points.
■ LEED MR 4.1 and 4.2: Recycled Content: Up to 2 points.
■ LEED MR 5.1 & 5.2: Regional Materials
CEMCO cold-formed steel framing products
contain 30% to 35% recycled steel.
These products are produced from steel consisting of the following contents:
■ Total Recycled Content: 32.9%
■ Post-Consumer Content: 25.6%
■ Pre-Consumer Content: 6.8%
■ CEMCO can provide higher recycled content based on blending steel. Please refer to SSMA
Tech dated May 2009 to calculate recycled content on blended steel.
■ Link to SSMA Tech Note dated May 2009 on LEED
®
2.2 Credits for Cold-Formed Steel Framing
Manufacturers: http://www.ssma.com/documents/TN06%20SSMA%20LEED%202.2.pdf
This technical information reflects the most current information available and supersedes any and all previous publications effective June 5, 2012