FAQ

ManualsBrandsUnbranded ManualsBuilding materials2149 7/16 in. x 2 in. x 108 in. Vinyl Sandstone Garage Door Stop Moulding

SAWING/CUTTING

• Use standard woodworking equipment for

most applications.

• If using a power miter saw, a carbide-toothed

blade with 80 teeth or more is recommended.

NAILING

• Use 6d and 8d galvanized nails.

• Pre-drilling is required at temperatures of 40˚F

or below.

• Royal Moulding can also be installed using a pneumatic nailer, with

stainless steel or painted head screws or with construction-grade adhesives.

GLUING

• Temperature variations will cause PVC mouldings

to expand and contract. To prevent open miter

joints, we highly recommend gluing all joints on

PVC mouldings using a quality instant glue, PVC

cement or OSI TeQ Bond.

• When assembling, splice and return miters by gluing the mouldings

together before installation. This will allow you to fit the joints easily,

and fasten the trim to the wall as one unit.

• Always test adhesive brands before using.

PAINTING

• Royal Mouldings require no painting for

protection, but can be painted with 100%

acrylic latex paint to achieve custom colors.

(Scuff sanding will optimize paint adhesion, but is

not required. A second coat may be needed to achieve desired color.)

• To maintain warranty for custom colors in darker shades, use

heat-reflective paint with VinylSafe

™

Technology from Sherwin-Williams.

(Dark colors are considered any color that falls within the lightness (L)

value of 56 to 0, with 100 being white and 0 being black.)

NOTE: We do not recommend painting the flex of Garage Door Stop

TOUCHUP FOR EXTERIOR MOULDINGS

• Dap® “All Purpose” Painter’s Putty®

• Minwax High Performance Wood Filler®

• Elmer’s Fill-N-Finish Light Wood Filler®

• Sherwin Williams Shrink Free Spackling®

After installation is complete, caulk and/or putty all gaps and nail holes.

CLEANING

• Royal Moulding can be cleaned using any of the

recommended household cleaners listed below;

however, glass cleaner has been shown to be

best at keeping the finish intact.

• Recommended cleaners: See list in FAQs.

• Apply the cleaning solution and immediately wipe dry for best results.

• Avoid harsh cleaners with glycol ethers, ethanol type solvents

and/or isopropyl alcohol as they can soften the PVC finish if left on

for several minutes.

Installation tips

Summary of content (2 pages)

PAGE 1
Installation tips SAWING/CUTTING • Use standard woodworking equipment for most applications. • If using a power miter saw, a carbide-toothed blade with 80 teeth or more is recommended. NAILING • Use 6d and 8d galvanized nails. • Pre-drilling is required at temperatures of 40˚F or below. • Royal Moulding can also be installed using a pneumatic nailer, with stainless steel or painted head screws or with construction-grade adhesives.
PAGE 2
FAQs BRICK MOULD & JAMB INSTALLATION 1. Remove old jamb, brick mould and garage door stop with a pry bar or hammer. 2. Measure the top opening from side to side and cut jamb to fit with a fine tooth power or hand saw. 3. Install top jamb piece using 8d galvanized finishing nails to 2x4 or 2x6 structural frame members. Alternate nailing from side to side, nailing every 12" and approximately 3/4" from each edge. Note: If nailing product at 40°F or below, pre-drilling is required. 4.