Installation Guide

ManualsBrandsUnbranded ManualsDimensional Lumber00401

#LB-4020 SPECIFIER’S GUIDE

Structural Framing Lumber with

Predictable Performance

• Computerized Grading Virtually Eliminates Warp

• Comes with Crown Edge Clearly Marked

• Eliminates Field Culling

• Protected with a Mold Inhibitor

• More Stable and Consistent than Ordinary Lumber

• Limited Product Warranty

FRAMER SERIES

™

LUMBER

WOODBYWY.COM 1.888.453.8358

Summary of content (4 pages)

PAGE 1
#LB-4020 SPECIFIER’S GUIDE FRAMER SERIES LUMBER ™ Structural Framing Lumber with Predictable Performance • Computerized Grading Virtually Eliminates Warp • Comes with Crown Edge Clearly Marked • Eliminates Field Culling • Protected with a Mold Inhibitor • More Stable and Consistent than Ordinary Lumber • Limited Product Warranty WOODBYWY.COM 1.888.453.
PAGE 2
STRAIGHT TALK ABOUT FRAMER SERIES™ LUMBER Weyerhaeuser’s Framer Series™ lumber is mechanically graded to virtually eliminate warping, and each board comes with the crown clearly marked to speed up installation. With lumber like this, framing goes up fast, crews won’t spend valuable time culling, and there’s less material waste when the job is done. Each piece of Framer Series™ lumber is performance tested to meet specific strength and density requirements.
PAGE 3
FRAMER SERIES™ LUMBER SPAN AND LOAD TABLES Maximum Floor Spans(1) 40 psf Live Load, 40 psf Live Load, 30 psf Live Load(3), 30 psf Live Load(3), 10 psf Dead Load, L/360 (2) 10 psf Dead Load, L/480 10 psf Dead Load, L/360 (2) 10 psf Dead Load, L/480 12" o.c. 16" o.c. 19.2" o.c. 24" o.c. 12" o.c. 16" o.c. 19.2" o.c. 24" o.c. 12" o.c. 16" o.c. 19.2" o.c. 24" o.c. 12" o.c. 16" o.c. 19.2" o.c. 24" o.c.
PAGE 4
FRAMER SERIES™ LUMBER ALLOWABLE HOLES AND NOTCHES For Wall Framing Safety 5⁄8" minimum edge distance Maximum hole diameter in bearing walls: – 13⁄8" in 2x4 studs – 23⁄16" in 2x6 or wider studs L ⁄3 L ⁄3 ■ DO NOT cut a notch and a hole in the same cross section ■ Do not use lumber as ramps, planks, etc. Use only as directed in this guide. ■ After sheathing, do not overload joists with construction material in excess of design loads.