Installation Guide

Figure 9: Convex Roof Juncture
Double or triple
starter course
Metal flashing
Sheathing
Correct construction of roof junctures and
slope transitions is vital to ensure the integrity
of the roof system. In the following cases,
where metal flashing is employed, it should be
no less than 26 gauge galvanized steel or
acceptable equivalent. Check with your local
building official for their preference in your
area. It should be painted on both sides with a
good metal or bituminous paint. Flashing
materials should be painted after bending to
maintain the integrity of the coating.
On this type of juncture (Figure 9) metal
flashings should be installed to cover the top
4" of the wall and the bottom 8" of the roof
slope before the final course of Certi-label
shakes or shingles is nailed to the top of the
wall. A strip of wood molding can be applied
after final wall course is installed. A double or
triple starter course is then applied at the
eave, with a 1 1/2" overhang over the outside
wall trim. The roof can then be completed in
the normal manner.
Metal flashings for the concave juncture are
similar to those for the convex type. They
should be installed to cover the top of the roof
slope and the bottom 4" of the
wall before the final course of Certi-label
shakes or shingles is installed. The final roof
course should be installed so that the tips fit as
snugly as possible against the wall at the
juncture. A double starter course should be
applied at the start of the wall surface and the
remaining wall courses applied in the
recommended manner. If nails are not
acceptable through exposed metal, metal clips
can be used to hold down the flashing.
Roof transitions (Figure 10) require
appropriate flashing, felt and product
application. Changes in roof slope should be
detailed in a similar manner as concave
junctures, to ensure the integrity of the roof
system. Solid sheathing is required above and
below the change in slope, metal flashing is
required across the change in slope, and a 36"
strip of starter felt is required on the upper
slope, installed in the same fashion as at the
eaves.
Convex Juncture
Concave Juncture
Roof Transitions
ROOF JUNCTURE DETAILS
Product should project
1 1/2 beyond the fascia
and approximately 1" over
the gable or rake end
"
Wood molding
8
Metal flashing
6" up - 6" below
Solid sheathing
Interwoven felt
for shakes only
36" starter felt
Product should project
1 1/2 beyond the fascia and
approximately 1" over
the gable or rake end
"
Double starter course
Steeper slope roof
Lower slope roof
Courtesy: Western Wood Products, Photo: John Spaulding
Figure 10 Low Slope to Steep Slope Roof
Transition Detail - Certi-label shakes
(Certigrade shingle application is similar but without felt interlay)