Manual

30 | P a g e
useful for testing or constant voltage sources.
The ON/OFF has to be set to OFF in order to change the operational mode. Scroll to the right to highlight
the word ON or OFF and use the up and down keys to change it to OFF. Push the Enter button to save this
change. Now you can scroll to the right and highlight the mode under Function. Scrolling up or down
changes the modes. Once a mode is selected push the Enter button to save this change. Then you can use
the right soft key to select ―setup‖. This would be where you will manually set up any parameters specific
to the mode you selected.
Configuring the Classic for Wind Input Source
Wind
If you selected ―Wind‖ you will need to select a power curve from the list of pre-loaded curves or build
your own. To access the list of power curves follow the steps below.
 Push the Main Menu button.
 Scroll left or right until ―Mode‖ is highlighted and push the Enter button.
 Set the status to OFF and then use the right soft key to select ―Graph‖.
Using the left soft key select ―MEM‖. Now you can scroll up and down through the menu and select from
the curve that was designed for your turbine. Once you find the correct power curve use the right soft key
to select ―RECALL‖. Now push the Enter button to save this power curve to the Classics memory.
There are also 9 memory spaces for you to save a custom power curve. To build custom power curves
select a memory location between 1 and 9 and hit ―RECALL‖. Use the right and left arrow buttons to
scroll through the 16 steps in the custom curve. On each step you can set the amperage by using the up
and down buttons. When you have the power curve the way you want it select ―MEM‖. Use the up and
down buttons to select a location 1 through 9 to save it in and select ―SAVE‖. Now push the Enter button
to save it to the Classic's memory.
For more information consult the videos contained in this DVD as well as the MidNite Solar web site.
Classic-Wind-Graph-Editor-1.mpg
Setting the Date and Time
To set the date and time manually on the Classic follow the steps below.
 Push the Main Menu button.
 Scroll left or right to highlight ―TIME‖ and push the Enter button
Now scroll left or right to highlight the data you want to manually change. Use the up and down buttons
to change the data. When you have all the data changed push the Enter button to save the changes.
The Classic includes a battery in the MNGP portion, to keep the time running even when the power is
disconnected. To replace the battery refer to the Installation Manual
Setting Longitude and Latitude
With the built in virtual map, you are able to select where you are in the world. For a more precise setting
you can manually enter the longitude and latitude coordinates, geographic location is important because it