Installation guide

No frame detected.

The receiver receives signals but no

valid frame is detected.

Please try the following actions to

solve this problem:

1. Make sure no other interfering

sources exist;

2. Increase txgain at the sender

side;

3. Increase rxpa and rxgain or

enable AGC at the receiver

side;

4. Move the antennas closer;

5. Adjust frequency offset. You

can find proper values using the

sine test;

6. Reset hardware and

disable/enable the drivers.

11.4.3 Misc functions

a) Save/Load calibrated parameters

Click save button (n) in the parameters group to save calibrated parameters in a file. A saved file

can be loaded by clicking the load button (o) in the parameters group. In log window (k), the

loaded parameters are displayed.

b) Save/Clear logs

Click save button (l) to save the messages in the log window to a file. Click clear button (m) to

clear the messages in the log window.

c) Dump

HVT can also save a snapshot of received signal in a dump file for further analysis. To make a

dump, HVT must run in the receiving mode. Clicking dump button (c) will save the signal to a file.