User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - 8
2.2.9 Setting The Graphic Output Screen Status:
The Graphic Output Screen Status feature enables the use of the plot and
data display screens from the Operator Screen. If the status is not checked, the
user will not be allowed to see any plots or data displays except for the Summary
Screen.
Step 1: Click in the check box button next to the Graphic Output
Screen Status button with the left mouse button, this toggles the On / Off
selection.
Step 2: Click on the <save> button.
2.2.10 Setting The Enable Delete Scan Status:
The Delete Scan Status feature enables the user to delete a specific scan. If
this is not checked the program will not allow the operator to delete a scan that may
have been in error.
Step 1: Click in the check box button next to the Enable Delete Scan
with the left mouse button, this toggles the On / Off.
Step 2: Click on the <save> button.
2.2.11 Setting The Single Edge Scan Status:
The Single Edge Scan feature enables the user to measure and analyze one
edge of the sample. This sample may or may not have holes; the scan runs fast with
no holes. If the status is not checked the program will automatically assumes that
the operator wishes to run a complete sheet.
Step 1: Click in the check box button next to the Single Edge Scan
Status button with the left mouse button, this toggles the On / Off.
Step 2: Click on the <save> button.