User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - 6
When this field is non-zero (1 - 11), the hole specification (diameter of
all holes, and for each hole its Horizontal and Vertical position on the sheet)
fields are enabled. The Hole Number field will be activated.
Step 2: Enter the diameter measurement for the holes, enter the
warning limits and the fail limits.
Step 3: Enter the hole position in the <Hole Number> field. This
number may be changed by pressing the up or down arrows.
Step 4: Enter the Horizontal Position measurement for each hole, enter
the Warning and Fail measurements.
Step 5: Enter the Vertical Position measurement for each hole, enter the
Warning and Fail measurements.
Step 6: Click on <Save> up by the Sheet Type area to store the changes,
new settings or changed measurement settings.
NOTE:
All measurements are tied to the current sheet selected in the Sheet Type area.
The Operator and Machine names are independent of sheet type.
NOTE:
All measurements are in inches or mm. except:
a. Hanging Fibers = Number of Hanging fibers / inch or mm.
b. Squareness = Degrees
c. Corner Quality = Square Inches or Square MM