User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - 5
from the list or click on the sheet name in the edit window to
alter the test name
Step 2: Click on <Save> to store the change.
2.2.5 Units:
Spec*Edge
™
allows you to set and read the results in either inches or
millimeters. Clicking on the down arrow in the units box allows you to select which
you would prefer.
2.2.6 Change The Test Measurement Specification Fields:
Step 1: For each test measurement place the cursor on the
measurement field to be changed or set by either highlighting
(dragging the mouse across the number while holding down the
left mouse button) or clicking at the end of the number with the
left mouse button and backspacing the old number out. Enter
the measurement number you want specified.
Step 2: Click on <Save> up by the Sheet Type area to store the changes,
new settings or changed measurement settings.
2.2.7 Change The Hole Measurement Specification Fields:
(If the sheet has no holes)
Step 1: Enter a "0" in the <Hole Count> field.
Step 2: Click on <Save> up by the Sheet Type area to store the changes,
new settings or changed measurement settings.
(If the sheet has holes)
Step 1: Enter the number of holes in the Hole Count field.