User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - 4
2.2.1 Add, Delete or Change An Operator:
The Operator area identifies the names of valid operators. One of the names
in the list may be edited by clicking with the left mouse button on the name.
Step 1: Click the left mouse button on <New Operator> to add an
authorized operator, click on <Delete> to remove an operator
from the list or click on the name in the edit window to alter the
operators name
Step 2: Click on <Save> to store the change.
2.2.2 Add, Delete or Change Machine Identification
The Machine area identifies the valid machines and the count identifies the
number of test sheet to be tested on this machine for a test (Number of sheets that
make up this test on this machine). The machine name and sheet count are linked.
Step 1: Click the left mouse button on <New Machine> to add a
machine, click on <Delete> to remove a machine from the list or
click on the machine name in the edit window to alter the
machine name
Step 2: Click on <Save> to store the change.
2.2.3 To Change the Sheet Count:
Step 1: Click on the left mouse button on <Sheet Count> window,
enter the number of test sheets that make up this test.
Step 2: Click on <Save> to store the change.
2.2.4 Add, Delete or Change The Sheet Type:
The Sheet Type and Test Specification area identifies the names of
sheets and the specification measurement fields that accompany them. The sheet
name is modified in a similar manner to machine and operator names. The
specifications are modified by either highlighting (dragging the mouse across the
number while holding down the left mouse button) or clicking at the end of the
number with the left mouse button and backspacing the old number out.
Step 1: Click the left mouse button on <New Sheet> to add a sheet
identification, click on <Delete> to remove a sheet identification