User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - 2
NOTE:
Once an organization has established their settings in Spec*Edge
™
it is
recommended that the initialization settings file be archived on a
backup floppy disk or other such media to protect the settings against
computer malfunction or hard disk failure.
2. Setup Screen
Figure 1 - Spec*Edge
™
Setup Button
Step 1: Click on the <Setup> button on the Operator Screen. Clicking
on the <Setup> button initializes the Password Screen shown
in Figure 2a or 2b. Prior to obtaining access to the Setup
Screen and being able to change the settings, the operator must
enter the required password. The password is entered in the
following block.
Figure 2a – Password Screen
2.1 Initially Setting and Changing The Password:
The correct password activates the Setup Screen. This screen is used to
modify existing settings as well as to create new settings. If the wrong password is
entered, the user can view the settings but cannot change them.
To initially set or to change the password the operator must:
Step 1: Click on the Setup Button (Figure 1).
Step 2: Enter the master password (contained in a separate letter to the
primary software license holder) in the Enter Password block
shown in Figure 2a. Once this password is entered and the
operator selects <OK>, the screen shown in Figure 2b appears.