User`s manual

Spec*Edge Version 3.9
June 11, 2008
Setup - i
SPEC*EDGE
™
SETUP
Section Page
1 Introduction ....................................................................................... 1
2 Setup Screen ...................................................................................... 2
2.1 Initially Setting and Changing The Password ....................... 2
2.2 Entering Test Specifications ...................................................... 3
2.2.1 Add, Delete or Change an Operator .............................. 4
2.2.2 Add, Delete or Change Machine Identification .......... 4
2.2.3 To Change the Sheet Count ............................................ 4
2.2.4 Add, Delete or Change the Sheet Type ........................ 4
2.2.5 Units ..................................................................................... 5
2.2.6 Change Test Measurement Specification Field .......... 5
2.2.7 Change Hole Measurement Specification Field ......... 5
2.2.8 Setting the Database Path .............................................. 6
2.2.9 Setting the Graphic Output Screen Status ................. 8
2.2.10 Setting the Enable Delete Scan Status ........................ 8
2.2.11 Setting the Single Edge Status ...................................... 8
2.2.12 Setting the Setup Path..................................................... 9
2.2.13 Selecting the Language .................................................... 9
2.3 Calibration ..................................................................................... 9
2.4 Returning To the Operator Screen ........................................... 10