User`s manual

Spec*Edge Version 3.9
June 11, 2008
Running - 9
(Single Edge) (Full Sheet)
Figure 4 – Sample Analyzed
5. Viewing Results:
NOTE:
The Button
located on the Setup screen must be checked
to allow the operator to view the graphic
analysis screens
Step 1: From the Operator Screen (Figure 4) click on the button for
the specific measurement where more data, specific measurements and
analysis is wanted.
Step 2: Click on the <Back> button to return to the Operator Screen.
As each sample is analyzed the operator may view the results of each
measurement by clicking with the left mouse button, first on the pocket to be
viewed and then on the specific measurement button. See the Analysis
Section of this manual for information pertaining to each measurement.
6. Printing Out Measurements Of A Single Pocket:
Step 1: Click with the left mouse button on the Summary
Button when all of the sample sheets have been scanned and analyzed to
bring up the Summary Screen as shown in Figure 5.