User`s manual

Spec*Edge Version 3.9
June 11, 2008
Running - 8
4. Running a Typical Spec*Edge
™
Test:
Step 1: Place the sample to be tested on the scanner glass as described
by the instruction for Figure 3
Step 2: Calibrate Spec*Edge
™
in accordance with the instructions in the
Setup Section, Paragraph 2.3.
Note:
Spec*Edge
™
should be re-calibrated each time the systems is started, a different
size sheet is measured, or the orientation of the sheet is changed.
Step 3: From the Operator Screen select the Operator, Machine No. and
complete any of the additional information blocks desired to show on the printout or
in the database.
Step 4: Select the <Scan> button. Spec*Edge
™
will automatically scan,
analyze and report the findings, as determined by the setup specifications.
Once the scan is complete you may place the second sample (if required) on
the scanner and click on the <Scan> button to start the second sheet in the
group. The analysis will be accomplished on each sheet in the order scanned
as fast as the computer can do the mathematics. As each sheet is analyzed
the OK/Warn/Fail lights will illuminate for the sheet that is indicated at the
top right of the Operator Screen.
Show the number of pockets (sheets) and the
progress of each.
Empty
Scanning
Complete
Invalid
Unknown