User`s manual

Spec*Edge Version 3.9
June 11, 2008
Running - 7
Cancel Scan/Delete
–
Allows you to cancel or
delete the scan. The Cancel button will
appear in place of the scan button during
scanning and the Delete appears after the
scan is complete. When this button is
activated, the Exit and New Test Button
disappear.
3. Prior to Scanning:
Spec*Edge
™
is measuring very small details on a sample, up to 8 times the
detail typically scanned by other commercial scanning programs. Any dirt or
defects on the scanner glass itself may be detected as a defect and invalidate the
results. Prior to using Spec*Edge
™
, inspect the scanner glass to insure that the
glass is clean. Dust and smears are only on the top side of the scanner glass. Do
not take your scanner apart because it is a sealed unit. Clean the top of the scanner
glass only. Use a soft sponge moistened (but not dripping) with warm water and a
mild soap detergent to clean the scanner glass. Do not allow the cleaner or the
water to seep around the edge of the glass into the scanner.
The cabinet may be cleaned with mild detergent. DO NOT USE ANY
CHEMICAL OR PETROLEUM BASED CLEANERS.
Place the paper sample on the scanner glass approximately centered. from
top to bottom, and 1/2 in. from the left side of the scanner glass aligned with the
instructions on the edge of the scanner (Figure 3). The holes (if any) should be
placed on the side labeled Right.
Figure 3 – The Scanner Glass