User`s manual

Spec*Edge Version 3.9
June 11, 2008
Analysis - 9
Figure 5 - Hole Image
3.8 Hole Image: The center of the hole is marked by a white “X”. The diameter
specifications are drawn around the hole in concentric circles. The green circle is
the nominal specification, the yellow circles are the warning (warn) limits, and the
red circles are the fail limits. The green plus (“+”) marks the location where the
center of the hole should be located. The yellow rectangle shows the horizontal and
vertical warn limits for the center position and the red rectangle shows the
horizontal and vertical fail limits. If the white “X” is inside the yellow box, then the
hole position is OK.
3.9 Corner Data: (Figure 6). Spec*Edge locates the correct position for the
corner of the sheet based on the slopes of the two edges of the sheet that make up
the corner. It then calculates the excess or lack of paper in the corner in square