User`s manual

Spec*Edge Version 3.9
June 11, 2008
Analysis - 3
NOTE:
The
Button located on the Setup screen must be
checked to allow the operator to view the
graphic analysis screens
Step 1: Clicking on the specific measurement button located on the left side of
the Sample Analyzed (Figure 1) with the mouse button. This brings up, as an
example, the following screen.
Figure 2a – Curvature Graph
3.1 Curvature Graph: Once the operator has selected the graph or data to
view, they may view all four sides of the sample by selecting the appropriate edge.
In this case we have selected the Curvature Graph (Figure 2a). Curvature
measures the amount of bend or bow in the knife blade. The operator may then
view the Cut Quality (Figure 2b), Distribution (Figure 2f) and Image (Figure
2g) of the edge by selecting the appropriate plot desired. The operator may also
zoom-in on a particular portion of the curvature or cut quality graph by clicking
with the left mouse button on the left side of the graph where they desire to start
the zoom and, while holding the left mouse button down, move the mouse pointer to
the right side boundary they desire, then release the left mouse button (Figures 2c,
2d).
NOTE:
Each graph starts 5/8 of an inch from each
side of the scanned sample.