Safety Instructions

EN
8
OPERATION
SHOOTS STEEL BBS ONLY!
CAUTION
NOTE: The airgun must be charged with CO
2
when following these steps but
remember, do not store your airgun with a CO
2
capsule in it..
IMPORTANT: Firing the airgun with too little gas pressure left may cause a BB to
get stuck in the barrel.
Removing a Jammed BB
• Make sure the air pistol is “ON SAFE”.
• Remove the magazine by pressing down on the magazine release button.
• Unload all of the BBs.
• Remove the CO
2
capsule.
• Insert a .177 caliber ramrod into the muzzle end of the barrel and carefully push
the jammed BB into the breech. The barrel could be damaged and the warranty
will be void if the proper sized ramrod is not used.
• Hold the air pistol upright and shake until the jammed BB falls out.
• If you are not able to unjam your air pistol by following this procedure, take
no further action. Call Umarex USA (479)-646-4210 and ask for the service
department.
• You and others with you should always wear shooting glasses to protect your
eyes.
• Always aim your air pistol in a SAFE DIRECTION. When you are sure of your
target and backstop, and the area around the target is clear, take “OFF SAFE”
and squeeze the trigger to re.
• Do not shoot at hard surfaces or the surface of water. Projectiles may bounce
off or ricochet and hit someone or something you had not intended to hit.
• Do not shoot at fragile surfaces such as glass or mirrors.
• Always choose your target carefully. Only targets which cannot be completely
penetrated or which will not cause ricochets should be used.
• Your backstop should be checked for wear before and after each use. Replace
your backstop if the surface is worn or damaged, or if a ricochet occurs.
• The air pistol is correctly aimed when the front sight blade is positioned exactly
in the notch and even with the rear sight. The top of the front sight blade should
be even with the top of the notch in the rear sight. The bullseye should appear
to rest on the top of the front sight.
5. Aiming and Firing Safely
To adjust sights (elevation only), press and
hold button, then slide forward or backward