Owner's Manual

EN
7
OPERATION
3b. Removing an Airgun from T•A•C Converter
• Puttheairgun“ONSAFE”(See Airgun’s
Instructions)
• PointtheairguninaSAFEDIRECTION
• Removethemagazinebypressingthemagazinereleasebutton(See
Airgun’s Instructions)
• RemovetheCO
2
capsule (See Airgun’s Instructions)
• Removefrontretainingpin(illustration 2)
• Retractstock(see section 5b)
• Firmlygraspairgungripinonehandand
T•A•CConverterinother;pulltheairgun
back, then forward (illustration 14)
• Flipdownretainer
• PulltheairgunbackandoutofConverter
• Reinsertfrontretainingpin
4. Adjusting the Rear Sight (Windage Only)
• Puttheairgun“ONSAFE”
( See Airgun’s Instructions )
• PointtheairguninaSAFEDIRECTION
• Removethemagazinebypressingthe
magazinereleasebutton
( See Airgun’s Instructions )
• RemovetheCO
2
capsule
( See Airgun’s Instructions )
• LaytheT•A•Conahard,flatsurface.
• Usingahammerandnylonpunch,lightly
tap on the side of the rear sight until it
is in the desired position. If the airgun
shoots too far to the right, tap the sight
on its left side. If the airgun shoots too far
to the left, tap the sight on its right side.
illustration 15
Shoots too
farleft;tapon
right side of
rear sight
Shoots too
farright;tap
on left side of
rear sight
5. Using the Foldable Grip and Stock
5a. To Adjust or Remove Grip
• Toextendgrip,folddownuntilitclicksintoplace(illustration 16)
• Toretractgrip,pressandholdgripreleaseandfoldgripup(illustration 17)
• Toremoveoradjustpositionofgrip,pressandholdrailbuttons(oneon
each side) and slide grip forward or back (illustration 18)
illustration 16 illustration 17 illustration 18
1.
1.
2.
2. 2.
5b. To Adjust Stock
• Toextendstock,graspstockandrotateout(illustration 19)
• Toretractstock,graspstockathinge,pullupandrotateback(illustration 20)
illustration 19 illustration 20
1.
2.
PINCH
POINT