Owner's Manual

EN
7
STEP 5. Loading Your Air Rie
Filling the BB reservoir - The loading door is
located on the left side of the receiver. Slide door
open and ll reservoir with approximately 75 BBs.
(illustration 5a) Do not overll or the feed system may
not operate properly.
LOADING BBs - With the bolt handle back and BBs
in the reservoir, RAISE the muzzle of the air rie 45
degrees to 90 degrees.
(illustration 5e).
When raising the muzzle, be sure the
front sight is pointed upward since the
air rie may not feed properly if it is on
its side (illustration 5b). A BB can be
seen on the magnetic tip by looking
into the loading port (see illustration 5c). If a BB does
not feed onto the magnetic tip when the muzzle is raised,
shake the gun slightly. Push bolt handle fully forward to
place the BB in ring position. NOTE: Do not load more
than one BB at a time.
Illustration 5b
LOADING PELLETS - With the bolt back and BBs
removed from the reservoir (See “TO EMPTY BB
RESERVOIR” STEP 6), lower the muzzle and load a
pellet into the loading port, solid end forward (illustration
5d). Push the bolt handle fully forward and the pellet
is chambered in the ring position. NOTE: Do not load
more than one pellet at a time.
OPERATION
LEAD PELLETS CONTAIN LEAD, A CHEMICAL KNOWN TO
THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM. DO NOT INHALE DUST OR PUT LEAD PELLETS IN MOUTH.
WASH HANDS AFTER HANDLING. KEEP AWAY FROM CHILDREN.
WARNING:
UNLOADING A PELLET - The magnetic tip does not extract a pellet. You must shoot
the pellet out into a safe target if available. If a safe target is not available, open bolt,
insert a .177 cleaning rod into the muzzle end and push the pellet out of the barrel. Do
not allow a pellet to fall into the rear of the loading port and become jammed in the BB
feeding hole.
TO EMPTY BB RESERVOIR - Open bolt, open the BB reservoir door, cup your hand
over it and tilt the Air Rie fully to the left side. Shake air rie until all BBs are removed.
Then remove BBs from loading port.
(see illustration 5c).
STEP 6. Unloading Your Air Rie
CLOSING THE PUMPING LEVER - Grasp the pumping lever, return it to the
closed position. (illustration 2c)
Illustration 5a
Illustration 5c
Illustration 5d