Owner's Manual

EN
12
OPERATION
WORKING PARTS: The working parts (pumping lever hinges, trigger hinges, bolt
and the foam wiper on the piston) require very little lubrication. Two(2) drops of
RWS Air Chamber Lube every 1000 shots will sufce. It is easily applied with a 3
1/2” applicator needle (see illustration 10). Remember, a little is good—a lot is
not better.
BARREL: In day to day use, very little dirt or residue will accumulate in the bore.
This can be removed by using RWS Cleaning Pellets. Note: High quality RWS
Lead Pellets not only increase accuracy, they help to reduce lead deposit. During
periods of regular use the bore of the barrel should be cleaned periodically by
means of a felt wad or cleaning rod with wool mop.
SURFACE: The exposed metal parts (rear sights, screw heads, trigger, etc.)
MUST be wiped clean using a slightly oiled cloth after handling to prevent rust.
Use light acid free and resin free oil. RWS Spring Cylinder Oil is excellent for this.
CHECK THE TIGHTNESS OF THE STOCK SCREWS BETWEEN, DURING, AND AFTER
SHOOTING ACTIVITY. LOOSE SCREWS MAY CAUSE INJURY.
CAUTION
AN AIRGUN THAT IS NOT OPERATING PROPERLY MAY
BE DANGEROUS. IT SHOULD BE KEPT SAFELY FROM USE BY ANYONE UNTIL
REPAIRED OR DESTROYED. DO NOT TRY TO TAKE THE AIRGUN APART. IT IS
DIFFICULT TO REASSEMBLE AND IMPROPER DISASSEMBLY OR REASSEMBLY
CAN CAUSE SERIOUS INJURY OR DEATH.
WARNING:
illustration 10
PUMPING LEVER
HINGES
FELT PAD
PUMP ROD
CAUTION
THE COMPONENTS OF THIS AIRGUN WERE ENGINEERED AND MANUFACTURED TO DELIVER
OPTIMUM PERFORMANCE. ANY MODIFICATION OR TAMPERING WITH AN AIRGUN MAY CAUSE
A MALFUNCTION, VOID YOUR WARRANTY AND MAY MAKE IT UNSAFE TO USE. ANY CHANGE
IN PERFORMANCE (SUCH AS A LOWERED TRIGGER PULL FORCE AND SHORTENED TRIGGER
TRAVEL) INDICATES POSSIBLE MODIFICATION, TAMPERING AND/OR WEAR. SUCH AIRGUN
SHOULD BE INSPECTED, REPLACED, OR PROPERLY REPAIRED BY ONLY QUALIFIED UMAREX
USA PERSONNEL. ANY AIRGUN THAT HAS BEEN DROPPED SHOULD BE CHECKED BY QUALIFIED
PERSONNEL TO ENSURE THAT ITS FUNCTION HAS NOT BEEN AFFECTED.