Owner's Manual

EN
10
OPERATION
STEP 9. Adjusting the Sights
The rear sight can be adjusted for windage (horizontal) and
elevation (vertical).
Elevation Settings—To raise point of impact on the target,
push the sight elevator toward the muzzle. To lower point of
impact on the target, push the sight elevator rearward, away
from the muzzle. (see illustration 7)
Windage Settings—Loosen windage adjustment screw “A”
by turning counterclockwise (see illustration 8). Adjust rear
sight to the right side of the air rie to make it shoot to the
right, or to the left side of the air rie to make it shoot to the
left. Make certain windage adjustment screw is retightened
after adjustment.
CLEARING A JAM - Open the bolt, if the bolt is not completely closed, do not try to
close it until after opening it by pulling the bolt handle all the way back. The air rie
will not re a projectile when the bolt is completely open. Repeat previous operations
except ( Do Not Load BBs or Pellets). Pump your air rie up 10 times, if a projectile still
does not re, follow these steps carefully:
1.) Open Bolt 2.) Clear barrel by running the correct caliber ramrod into the muzzle
end and push the projectile out (see illustration 9). Be careful not to damage the bolt
tip by pushing the rod through too hard. Do not reuse this BB or pellet. If you are not
able to unjam your air rie, contact Umarex USA’s Service Department.
STEP 10. Trouble Shooting
Illustration 8
Illustration 9
Bolt
Muzzle End
Screw “A”
Illustration 7
Correct Sight Elevator Position
Sight
Elevator
LOWER RAISE