APX OPERATION MANUAL ™ Multi-Pump Pneumatic Air Rifle Shoots Pellets or BBs Caliber Velocity .177 .177 800 fps (245 mps) w/alloy pellet 800 fps (245 mps) w/alloy pellet or STEEL BB .17 7 (4 , 5 mm) stock i e té a ut oma t aut i qu e 7 (4 , 5 mm) syn t hét que PELLET .
EN SAFETY INSTRUCTIONS WARNING: THIS AIRGUN CAN CAUSE SERIOUS INJURY OR DEATH. READ AND FOLLOW THE INSTRUCTIONS CAREFULLY. DO NOT LOAD A PROJECTILE INTO THE AIRGUN UNTIL YOU ARE READY TO SHOOT. IF YOU DO LOAD A PROJECTILE AND THEN DECIDE NOT TO SHOOT, REMOVE IT EITHER MANUALLY OR BY SHOOTING THE AIRGUN AT A SAFE TARGET. AN UNLOADED, UNPUMPED AIRGUN WHICH IS “ON SAFE” IS SAFEST. ACCIDENTS HAPPEN FAST, PLEASE HANDLE THE AIRGUN SAFELY.
SAFETY INSTRUCTIONS CARE EN STEP 1. Reviewing Safety • Always keep the muzzle of the airgun pointed in a SAFE DIRECTION. • Always keep your finger off the trigger and out of the trigger guard until ready to shoot. • You and others with you MUST always wear shooting glasses to protect your eyes. If you wear reading glasses the lenses must be certified for impact resistance or you should wear safety glasses intended for use over normal optical reading glasses. • Always aim in a SAFE DIRECTION.
EN DESCRIPTION STEP 2.
EN OPERATION WARNING: BE SURE THE AIRGUN IS ALWAYS POINTED IN A SAFE DIRECTION. NEVER POINT THE AIRGUN AT ANY PET OR PERSON EVEN IF IT IS UNPUMPED AND UNLOADED. ALWAYS ASSUME AND HANDLE THE AIRGUN AS IF IT WERE LOADED AND READY TO FIRE. CAUTION • ALWAYS MAKE SURE THAT THE MUZZLE POINTS IN A SAFE DIRECTION. • ONLY HANDLE THE AIR RIFLE WHEN IT IS ON SAFE. STEP 3. Operating the Safety The NXG™ APX™ Air Rifle has an automatic safety. To put “ON SAFE”, push the safety slider to the SAFE (S) position.
EN OPERATION WARNING: DO NOT OPEN THE BOLT, CLOSE THE BOLT AND THEN PULL THE TRIGGER BEFORE PUMPING. THIS PROCEDURE CAN RESULT IN A LOADED GUN AND A PROJECTILE BEING EXPELLED FROM THE GUN DURING PUMPING. OPENING THE BOLT, PUMP, THEN CLOSE THE BOLT. STEP 4. Pumping Your Air Rifle Open the bolt. (illustration 3). It must be open to pump the airgun. For added safety, leave the bolt open while pumping. Keep the muzzle pointed in a safe direction, then pump the airgun.
EN OPERATION STEP 5. Loading Your Air Rifle Filling the BB reservoir - The loading door is located on the left side of the receiver. Slide door open and fill reservoir with approximately 75 BBs. (illustration 5a) Do not overfill or the feed system may not operate properly. LOADING BBs - With the bolt handle back and BBs in the reservoir, RAISE the muzzle of the air rifle 45 degrees to 90 degrees. (illustration 5e).
EN OPERATION CAUTION USE ONLY .177 CALIBER (4.5 MM) PELLETS OR STEEL BBs. DO NOT ATTEMPT TO REUSE PELLETS OR STEEL BBs THAT HAVE BEEN FIRED OR ARE DEFORMED. DO NOT USE BUCK SHOT, DARTS, BALL BEARINGS, OR OTHER FOREIGN OBJECTS BECAUSE THEY CAN CAUSE INJURY TO YOU OR SOMEONE ELSE OR MAY DAMAGE AND/OR JAM THE AIRGUN. STEP 7. Aiming at a Safe Target Always aim your air rifle in a SAFE DIRECTION. Always choose your target carefully.
e OPERATION EN STEP 8. Firing Your Air Rifle When you are absolutely sure your air rifle is aimed at a safe target and you are ready to fire, put your air rifle “OFF SAFE” (see STEP 3. OPERATING THE SAFETY). Squeeze the trigger. WARNING: IF A PROJECTILE DOES NOT FIRE AFTER COMPLETING THE OPERATION STEPS, THE AIRGUN MAY BE JAMMED. AN UNFIRED PROJECTILE IN THE BARREL CAN BE A DANGEROUS SITUATION. KEEP THE AIRGUN POINTED IN A SAFE DIRECTION AND REPEAT THE OPERATION STEPS.
EN OPERATION STEP 9. Adjusting the Sights The rear sight can be adjusted for windage (horizontal) and elevation (vertical). Elevation Settings—To raise point of impact on the target, push the sight elevator toward the muzzle. To lower point of impact on the target, push the sight elevator rearward, away from the muzzle. (see illustration 7) Windage Settings—Loosen windage adjustment screw “A” by turning counterclockwise (see illustration 8).
ll OPERATION CARE EN STEP 11. Care and Maintenance CAUTION BEFORE ANY CARE, CLEANING OR MAINTENANCE, ALWAYS BE SURE YOUR AIRGUN IS UNLOADED. KEEP POINTED IN A SAFE DIRECTION. IT IS IMPORTANT TO PERFORM ROUTINE INSPECTIONS AND MAINTAIN YOUR AIRGUN PROPERLY. NEVER STORE A LOADED OR PUMPED AIRGUN. Unload pellet from the airgun. Keep air rifle away from unsupervised children and untrained shooters. Store projectiles separately from the air rifle.
EN OPERATION WORKING PARTS: The working parts (pumping lever hinges, trigger hinges, bolt and the foam wiper on the piston) require very little lubrication. Two(2) drops of RWS Air Chamber Lube every 1000 shots will suffice. It is easily applied with a 3 1/2” applicator needle (see illustration 10). Remember, a little is good—a lot is not better. BARREL: In day to day use, very little dirt or residue will accumulate in the bore. This can be removed by using RWS Cleaning Pellets.
lt . g s. CARE EN STEP 12. Repair / Service / Warranty Do not return defective or damaged product to the dealer. If your airgun needs repair, call Umarex USA (479) 646-4210 and ask for the Service Department or visit www.umarexusa.com. DO NOT ATTEMPT TO DISASSEMBLE IT! Your airgun requires special tools and fixtures to repair it. Any disassembly or modification not performed by Umarex USA will void the warranty.
NOTES ES s s o e or , L, 41
NOTES
NXG™ APX™ Specifications Multi-Pump Action Pneumatic Caliber / Ammunition LOP Trigger Weight .177 Cal. (4.5 mm) Lead Pellet 14.25" (36.2 cm) 3.5 lbs. (1.6 kg) 3.4 lbs. (1.5 kg) Caractéristiques du NXG™ APX™ Multi-Pump Action Pneumatic 4.5 mm (.177 Cal.) Calibre / Projectiles de Projectiles Plomb Distance 36.2 cm (14.25") détente/crosse Détente Poids 1.6 kg (3.5 lbs.) 1.5 kg (3.4 lbs.
7 (4,5 m vélocité i cro .17 7 (4 , 5 mm) e té a ut oma t stock aut i qu e 800 fps syn t hét que sse or STEEL BB m) sûr PELLET .17 omatic can on rayé barrel This OWNER'S OPERATION MANUAL should always accompany the airgun and be transferred with it upon change of ownership or when presented to another person.
