Owner's Manual

5
EN
OPERATION
3B. Removing a CO
2
Capsule
• Put the airgun “ON SAFE.” (See Step 2A)
• Turn the piercing screw on the bottom of the grip counterclockwise,
until you hear gas start to escape, being careful not to come in contact
with the escaping gas. Allow all the gas to escape.
• Continue turning the screw counterclockwise.
• Remove the backstrap by pressing the backstrap release button and
sliding the backstrap down (see Step 3A).
• Remove the CO
2
capsule.
5. Loading and Unloading BBs
4. Adjusting the Velocity
5A. Loading BBs
• Put the airgun “ON SAFE” (See Step 2A).
• Point the airgun in a SAFE DIRECTION.
• Locate the BB follower (illustration 8) on the left
side of the airgun. Push the BB follower towards
the muzzle and lock it in place.
• Insert up to 30 BBs into the BB magazine and
gently release the BB follower (illustration 9).
• Your airgun is now loaded and ready to re only
after reading the entire manual, including section
11 on reviewing safety.
4A. Lower Velocity
• Empty the BB magazine (See Step 5B).
• Put the airgun “ON SAFE” (See Step 2A).
• Point the airgun in a SAFE DIRECTION.
• Locate the velocity adjustment screw on the back of
the airgun (illustration 7).
• Turn the screw clockwise one and a half revolutions.
4B. Higher Velocity
• Empty the BB magazine (See Step 5B).
• Put the airgun “ON SAFE” (See Step 2A).
• Point the airgun in a SAFE DIRECTION.
• Locate the velocity adjustment screw on the back of
the airgun (illustration 7).
• Turn the screw counter-clockwise one and a half revolutions.
5B. Unloading BBs
• Put the airgun “ON SAFE” (See Step 2A)
• Empty the BB magazine.
• Aim the airgun in a SAFE DIRECTION, take it “OFF SAFE”
(See Step 2B) and re.
• Repeat this procedure several times until you are sure you are no
longer ring BBs and/or the BB magazine is empty.
SHOOTS STEEL BBS ONLY!
CAUTION
KEEP HANDS AND FACE AWAY FROM ESCAPING CO
2
GAS.
IT CAN CAUSE FROSTBITE IF ALLOWED TO COME IN CONTACT WITH SKIN. ALWAYS
MAKE SURE THE CO
2
CAPSULE IS EMPTY BEFORE ATTEMPTING TO REMOVE IT FROM
THE AIRGUN BY SLOWLY TURNING THE GAS CAPSULE PUNCTURE SCREW COUNTER-
CLOCKWISE ALL THE WAY UNTIL YOU NO LONGER HEAR THE ESCAPE OF CO
2
GAS.
WARNING:
Illustration 9
Illustration 8
Illustration 7
velocity
adjustment
screw
USE ONLY .177 CALIBER (4,5 MM) STEEL BBS. DO NOT ATTEMPT TO REUSE BBS THAT HAVE
BEEN FIRED OR ARE DEFORMED. DO NOT USE BUCK SHOT, DARTS, BALL BEARINGS, OR OTHER
FOREIGN OBJECTS BECAUSE THEY CAN CAUSE INJURY TO YOU OR SOMEONE ELSE OR MAY
DAMAGE AND/OR JAM THE AIRGUN.
CAUTION