Owner's Manual

3. Operating the Safety

4. Charging with Gas

OPERATION

To reduce chance of ﬁre or explosion:

• Always check gas can and charging adapter valve seal. Do not use if gas can has any

unusual dent or rust and/or seal is loose.

• Attach charging adapter outdoors, away from ﬂames or sparks or any other source that

could ignite gas.

• Check for leaks in one or more of these ways: Apply soapy water to all connections. LOOK

for bubbles, LISTEN for hiss of escaping gas, FEEL for extreme cold, and SMELL for rotten

egg odor. If leaking is found, do not use.

CAUTION

NOTICE

This airsoft gun has an automatic trigger safety.

Keep hands and face at a safe distance from the escaping gas. Escaping gas may cause

frostbite. Gas may explode if exposed to temperatures exceeding 122ºF. Do not smoke, keep

away from open ﬁre and ﬂames. The gas is highly ﬂammable.

CAUTION

Point top of magazine away from face and body. Escaping

gas may freeze skin.

WARNING

1. Press the magazine release.

2. Remove the magazine.

3. Pull down and hold the Spring Retaining Block.

4. Remove the Magazine Floor Plate.

5. Invert can and make sure charging nozzle is

perpendicular to the valve stem (in gas reservoir). Press

nozzle into magazine reservoir for 2-3 seconds. Repeat

as necessary until reservoir is full. The magazine is fully

charged when you observe a discharge of gas from the

valve stem.

6. Replace the Magazine Floor Plate.