Owner's Manual

EN
11
OPERATION
When you are absolutely sure your air rie is aimed at a safe target and you
are ready to re, put your air rie “OFF SAFE” (see STEP 2. OPERATING THE
SAFETY). Squeeze the trigger.
9A. Unloading a Pellet
Fire the pellet at a SAFE TARGET to unload the airgun. If this is not practical,
put the air rie “ON SAFE”, cock the bolt back to open the breech, and push the
pellet from the chamber by running a cleaning rod through the muzzle end. Insert
2 RWS Cleaning Pellets and discharge into a safe target.
9B. Removing a Jammed Pellet
NEVER LOOK DOWN THE MUZZLE.
If a pellet is jammed in the barrel, DO NOT reload the air rie.
1. Cock the air rie (by pulling back on the bolt),
push the bolt forward and lock. Point the air rie in
a SAFE DIRECTION, put the air rie in the “OFF
SAFE” position and squeeze the trigger to re.
NOTE: The air rie must be charged with CO
2
when following these steps but remember, do not
store your air rie with a CO
2
capsule in it (See
Step 3).
2. If the air rie is still jammed, de-charge the air rie. (see Step 4)
3. With the bolt locked back, insert the correct caliber ramrod into the muzzle and
push the jammed pellet out. Do not try to reuse that pellet. If you are not able to
unjam your air rie, contact Umarex USA’s Service Department.
9. Trouble Shooting
Breech
Muzzle
Illustration 18
DO NOT FIRE WITH THE BOLT OPEN. THIS MAY RESULT IN INJURY AND/OR A DAMAGED BOLT
AND WILL VOID YOUR WARRANTY.
CAUTION
IMPORTANT: Firing the airgun with too little gas pressure left may cause a pellet
to get stuck in the barrel.