User's Manual

Fig. 12
4.2 Unloading the Pellets
Put air pistol "On Safe" (See 2.1).
Open the barrel (See 4.1).
Remove the pellet clip. Using a ramrod, gently push each pellet out of the pellet chamber.
IMPORTANT: Never use sharp metal tools to remove pellets.
Check to make sure the barrel is completely unloaded by pointing the muzzle in a SAFE DIRECTION,
taking "OFF SAFE" (See 2.2) and pulling the trigger to fire. You may also unload your air pistol by
following the directions listed under Step 9 - Removing a Jammed Pellet.
Replace the empty pellet clip (ratchet teeth facing the rear sight) on the barrel (See Fig. 11).
Close the slide by pushing it all the way back until it locks into place (See Step 4.1) (Fig.12).
Do not place your
hand or fingers over the muzzle. Do not
put your finger on the trigger and make
sure your air pistol is pointing in a SAFE
DIRECTION when closing the slide.
Failure to follow this warning may cause
serious injury.
WARNING:
Close the air pistol by gripping the slide
and pushing it back until it locks into place
(Fig. 12).
slide rail
redhawk_usa.qxd 05.10.2004 07:26 Seite 8