User's Manual

8. Battery change
The red dot sight is powered by a 3 volt lithium battery (CR 2032).
The battery has to be changed when the red aiming dot loses its brightness or
disappears altogether.
Put the airgun “On safe” (2.1)
Remove the CO
2 magazine (3.2)
Remove the pellet clip (4.2)
Lift the grip plate off as shown in fig. 15 and change the battery.
After the battery change, put the upper section of the grip plate
into position first (fig. 16)
Place the bottom part of the plate in to position next. To do this, you will
have to slightly bend the grip plate.
To do so, place your index finger inside the frame,
to help guide the grip (fig. 17)
With your thumb on the outside of the frame, press the grip plate and
slide it down in to position.
Fig. 15
Fig. 16
Fig. 17
redhawk_usa.qxd 05.10.2004 07:27 Seite 12