User's Manual

6. Sights
This airgun has a built-in sight which projects a red dot on an internal
screen.
Using the red dot sight.
Make sure to point the airgun in a SAFE DIRECTION.
Locate the switch on the back strap of the grip.
Push in and hold the switch to turn the red dot sight on. (Fig.13.)
Release switch to turn the red dot sight off.
Adjusting the sight
The brightness adjustment is located at the base of the back strap.
Slide to the right to make the red dot brighter. (Fig.13.)
This airgun can be adjusted to shoot higher or lower (elevation) or left
to right (windage)
If the point of impact is too high,
turn the elevation adjustment screw clockwise.
If the point of impact is too low,
turn the elevation adjustment screw counter-clockwise.
If the point of impact is too far right,
turn the windage adjustment screw counter-clockwise.
If the point of impact is too far left,
turn the windage adjustment screw clockwise.
The Airgun is zeroed at a distance of 10 m, optimum performance
will occur at this distance.
Fig. 13
Fig. 14
redhawk_usa.qxd 05.10.2004 07:26 Seite 10