Unit installation

ManualsBrandsUltraViolet Devices ManualsNetwork CardHigh Output UV Device V-Flex

Lamp socket ID number on end plate

Secure lamp socket connector to lamp

Insert the lamp in a level, horizontal position.

Screw the lamp socket cap into place

UV Lamp securely inside locking mechanism

USD-RBE Series units only

Once it has been verified that there are no leaks in the system,

the UV lamps are ready for installation.

1. Remove all power to the UV unit.

2. Depressurize the system.

3. Wear clean cotton gloves to prevent contamination of

the UV lamps.

4. Carefully remove each UV lamp from the factory packaging.

Handle these with care as they are fragile.

5. Visually inspect all lamps for cracks or damage.

Do not install damaged lamps.

6. Using both hands, slowly insert the lamp into the quartz sleeve by

pushing it with one hand while guiding it with the other in a level,

horizontal position. This is very important. If not installed

properly, lamp or quartz breakage will occur.

7. Twist the lamp into the locking mechanism of the compression nut.

This ensures the lamp is secure within the chamber.

8. Each lamp socket is identified with a number that corresponds to

each lamp position marked on the end plate. Match the lamp socket

and connect to the appropriate lamp.

9. The lamp pins must be pushed down to fit securely in the lamp

socket connector.

10. Rotate and screw the lamp socket cap into place. Only hand

tightening is required. Do not overtighten!

CAUTION!CAUTION!

CAUTION!

Prior to energizing thePrior to energizing the

Prior to energizing the

ballasts and lamps, ensure there isballasts and lamps, ensure there is

ballasts and lamps, ensure there is

no wno w

no w

ter leaking into the quarter leaking into the quar

ter leaking into the quar

tztz

sleeves and compression nut cavi-sleeves and compression nut cavi-

sleeves and compression nut cavi-

ties by properly installing theseties by properly installing these

ties by properly installing these

components. Even a small leak cancomponents. Even a small leak can

components. Even a small leak can

lood a quarlood a quar

lood a quar

tz sleetz slee

tz slee

and comprand compr

and compr

ession nession n

ession n

ut caut ca

ut ca

vityvity

vity

During operation, high voltage is presentDuring operation, high voltage is present

During operation, high voltage is present

at the lamp pins and receptacles of theat the lamp pins and receptacles of the

at the lamp pins and receptacles of the

lamp connectors. Prolonged flooding oflamp connectors. Prolonged flooding of

lamp connectors. Prolonged flooding of

a quara quar

a quar

tz sleetz slee

tz slee

e and compre and compr

e and compr

ession nession n

ession n

utut

cavity can cause premature failure ofcavity can cause premature failure of

cavity can cause premature failure of

the lamp due to repeated arcing, over-the lamp due to repeated arcing, over-

the lamp due to repeated arcing, over-

heating of the lamp connector cable,heating of the lamp connector cable,

heating of the lamp connector cable,

and may result in a meltdown of theand may result in a meltdown of the

and may result in a meltdown of the

cable insulation.cable insulation.

cable insulation.