Specifications

The Ultratec TDD Detector uses two built-in
RJ12C telephone modular jacks to connect
directly to the telephone and the telephone line.
These jacks are located on the back panel of the
TDD Detector, and are labeled "LINE" and
"TELEPHONE."
1. Install the TDD Detector in a place that is
convenient for your operator.
You can place the operator's telephone on top of
the TDD Detector. The operator should be able
to reach the buttons on the front panel easily.
2. Connect the TDD Detector to the phone
line.
Use the modular telephone wire included with
your TDD Detector.
If you have a single phone line…
Plug one end of the modular phone wire into
the jack labeled "LINE" on the back panel of
your TDD Detector. Plug the other end of the
phone wire into the telephone line outlet.
If your setting has either a multi-line
(KTS) telephone system, or a call-director
console…
Connect the TIP and RING for the telephone or
from the call-director console to a telephone
wire with a modular plug that fits a RJ12C
modular jack. Plug the phone wire into the jack
labeled "LINE" on the back panel of your TDD
Detector.
3. Connect the operator's telephone to the
TDD Detector.
Plug the modular phone wire from the
operator's telephone into the "TELEPHONE"
jack on the back panel of the TDD Detector.
4
Manual reset
installation
instructions