Specifications

Setting pulse dialing +
The Supercom 4400 is set for tone dialing, which is correct for
almost all telephone lines. You can, however, change the setting to
pulse dialing if your line does not accept tone dialing. This setting
remains changed until you change it again or reset the Supercom
4400 or lose power. Follow these steps to set pulse dialing:
1. Press the options key ( + ). You will see PRINT
(UP/LOW) CASE on the display.
2. Press the key until you see USING (TONE) DIAL on
the display.
3. Press the to change the setting to PULSE.
4. Press the key to save the setting and leave options or press
the key to save the setting and go to the next option.
Setting the number of auto-answer rings
+
Follow these steps to change the auto-answer rings setting to any
number between 2 and 9 or TS:
1. Press the options key ( + ). You will see PRINT
(UP/LOW) CASE on the display.
2. Press the key until you see AUTO ANSW RINGS (2)
on the display.
3. Press the to change the setting to a number between
2 and 9 or TS.
4. Press the key to save the setting and leave options or press
the key to save the setting and go to the next option.
Return
Esc
Spacebar
Return
9Ctrl
9Ctrl
Return
Esc
Spacebar
Return
9Ctrl
9Ctrl
OPTIONS • 63