Instruction manual

H
V
-
Replacing the
Batteries
I f you r batteries
consistently run
down too soon after
recharging, you may
need to replace
them. But
fi rst try
giving the batteries
some
"exercise."
Follow the
instructions on page
8 before you replace
the batteries.
IMPORTANT!
If you need to
replace the standard
Mi n icom batteries,
use only NiCad size
AA rechargeable
batteries.
If you need to
replace the optional
heavy-duty batteries,
order a new battery
pack from U
Itratec
or your Ultratec
dealer.
Using batteries other
that those specified
in this manual may
damage
yo ur
Minicom and will
void your warranty.
1. Remove the cover to
the Minicom battery
compartment.
Press in at the back of the
cover and
lift up.
2. Lift the battery
holder out
of the case
and remove the old
batteries.
You will need to unsnap the
connector and slip
off the
paper sleeve.
3. Insert six new NiCad
size
AA rechargeable
batteries into the
holder.
Make sure to put the
batteries
into the holder with
the + and - ends going the
right way.
4. Replace the paper
sleeve, snap the
connector back on, and
put the battery holder
back
in the case.
Connect the AC charger/
adapter for 24 hours
to
charge the new batteries.
Minicom IV™
Comes With a
Built-I n
Printer
Po rt
The Minicom IV
pri nter port
is inside
the battery compart-
ment. Use it to
connect your
Minicom IV to a
pri nter to print you r
TOO conversations
Printer cables
are
available from your
U Itratec dealer.
6