Operation Manual

Fold & Go Model 370 Owner’s Manual
EMC Part: 19269600 • Rev. 03 • 04/11/05
29
Figure 16 — Aligning the Quick Release Drivetrain
3. (For models equipped with Quick Release Drivetrain)
Position rear of frame over top of drivetrain so that slots
of the drivetrain align with struts in the rear of the frame,
as shown in Figure 16. Slide frame onto drivetrain. Push
down on rear of frame until Drivetrain clicks into
position.
4. Make sure brake lever is in drive mode (Fuel Gauge will
flash on & off if Brake is in push mode and key is “On”).
5. Position seat frame into position, making sure seat legs
are repositioned into front leg sockets on frame.
crossover bar seats onto folding chassis. (Reference
Figure 2 - pg 8) Lower seat frame until rear seat latch
snaps into locked position onto frame.
6. Install Battery Pack (see “Installing the Battery Pack” on
page 9).
7. Position tiller into preferred driving positions.
8. Turn key to “ON” position. If no power or fuel gauge is
flashing, check connection at drivetrain or confirm that
brake lever is in drive mode.