Operation Manual

Fold & Go Model 370 Owner’s Manual
EMC Part: 19269600 • Rev. 03 • 04/11/05
27
4. Rotate Tiller Release Lever and lower tiller onto frame.
Secure Tiller to Frame with provided straps.
Figure 14 — Lowering the Tiller
5. Unplug drivetrain motor from connection beneath frame by
squeezing plug sides inward and pulling to disconnect.
Loosen and remove the two Drivetrain Attachment Knobs
on the back of the folding chassis, as shown in Figure 14.
Lift rear of scoter. Drivetrain will release and remain on the
ground.
6. (For models equipped with Quick Release Drivetrain) Pull
quick release drivetrain handle, as shown in Figure 15.
While handle is pulled, lift rear of scooter. Drivetrain will
automatically release electrically and remain on the ground.
Figure 15 — Quick Release Drivetrain Handle
If you are disassembling the Fold & Go Model 370 for shipping
or transport, refer to “Tr ansporting the Fold & Go Model 370”
on page 36 for recommendations and procedures suggested
for easy transport.