Operation Manual

Fold & Go Model 370 Owner’s Manual
EMC Part: 19269600 • Rev. 03 • 04/11/05
9
Battery Pack Installation
The Battery Pack is mounted directly into the frame, above
the drivetrain, and secured by a spring-loaded latch. When
in position, electrical contact is made automatically, no
further connections are required. Battery installation is
shown in Figure 3.
Figure 3 — Installing the Battery Pack
To install the Battery Pack:
• Use handle to lift Battery Pack into position
• Once alligned in battery slot, allow pack to slide
down into place. Electrical and Mechanical
connections will engage when pack is fully seated in
slot.
Battery may not be fully charged upon initial installation.
Refer to the following section to recharge the Battery Pack
of your Fold & Go.