Operation Manual

Fold & Go Model 760 PowerChair Owner’s Manual

EMC Part: 19272200 • Rev. 01 • 01/05/04

Seat Installation

The seat is mounted on a folding, tubular frame that

attaches directly to the chassis of the vehicle. A Quick-

Release latch at the bottom rear of the vehicle frame

secures the frame in place. To install the seat:

• Tilt the seat frame forward into the two front

locations on the frame of the vehicle

•Lower the rear end of the seat frame into the rear

locations in the chassis

• Make sure the Seat Latch springs into locked position

Seat installation is shown in Figure 3.

Figure 3 — Installing the Seat