Product Manual

Page 7 of 13
1) Place pawl in reel out position. Reel the old cable all the way out by turning handle
counterclockwise.
2) Loosen the nut and remove the old cable from underneath the cable clamp.
3) Remove the old cable.
4) Route new cable end over bushing and through the hole to the outside of the drum.
5) Install the cable under the cable clamp.
6) Tighten the nut securely.
7) Placepawl in reel in position, then reel the new cable onto drum by turning the handle clockwise,
being careful not to allow kinking.
 Test winch for proper operation.
 If nylon strap is used, it should have a loop sewn in one end and be attached using a 3/8" x 3" or
1 /4" x 2-3/4" long bolt and locknut. Use a locknut, not a nut, and lockwasher. Insert bolt through
slots in both reel side plates so that nut is on gear side.
 Tighten only until snug with bolt in bottom of slot next to reel hub.
Main Parts of Winch