Product Manual

IMPORTANT SAFETY CONSIDERATIONS
• If mounting this product requires drilling holes, the installer MUST be sure that no
vehicle components or other vital parts could be damaged by the drilling process.
Check both sides of the mounting surface before drilling begins. Also de-burr any
holes and remove any metal shards or remnants. Install grommets into all wire
passage holes.
• Do not use a pressure washer to clean this product.
WORKLIGHT USE AND CARE
• Do not modify the worklight in any way. Unauthorized modification may impair
the function and/or safety and could affect the life of the product.
• Always check damaged or worn out parts before using the work light.
Broken parts will affect the worklight operation. Replace or repair damaged or
worn parts immediately.
• Store idle worklight. If the worklight is not permanently installed, when the work
light is not in use, store it in a secure place out of the reach of children. Inspect it
for good working condition prior to storage and before reuse.
INSTALL THE WORKLIGHT
• Select a mounting location that will give you a maximum beam adjustment range
and will not cause any obstruction for your vehicle’s normal functions.
• Drill a mounting hole for mounting bolt (3) on the mounting surface. Insert
mounting bolt (3) to the middle hole of U bracket (2). Then run hexagon bolt（6）
from side hole of U bracket, light, then attach Washer(7) and nut(8)
• Insert mounting bolt (3) on the U bracket (2) to the mounting surface (hole drilled).
Then attach the washer (4) and nut (5). Do not over tighten the screws
MAINTENANCE
• It is recommended that the general condition of the worklight be examined before
it is used. Keep your worklight in good repair by adopting a program of
conscientious repair and maintenance. Have necessary repairs made by qualified
service personnel.
• Clean the surface of worklight lens frequently to keep its brightness.
• When any malfunction occurs, stop using and repair it immediately as soon as
possible. Please operate your worklight according to the proper operation
procedures.