Product Manual

Page of 4
2
Thank you very much for choosing an Ultra-Tow product! For future reference, please complete the
owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to
become familiar with this product before you begin using it.
This jack is designed for certain applications only. The distributor cannot be responsible for issues
arising from modification. We strongly recommend this jack not be modified and/or used for any
application other than that for which it was designed. If you have any questions relative to a particular
application, DO NOT use the jack until you have first contacted the distributor to determine if it can or
should be performed on the product.
For technical questions please call 1-800-222-5381.
INTENDED USE
This reliable, easy-to-use 2¹⁄₄ " dia. tube jack with a deep-seated snap ring provides side load support.
The large 1/2" pull pin activates the swivel mechanism, allowing the jack to swing up and out of the
way when not in use. The topwind model (Item# 44069) has a red claw knob on a clear zinc solid bar
handle that folds away when not in use. The sidewind model (Item# 44070) has a large, comfortable
grooved handle that makes cranking almost effortless. A grease zerk is built in for easy greasing of the
jack. A 3³⁄₄ " x 7¹⁄₂ " sand foot is welded on for stability. Both models feature a durable,
corrosion-resistant exterior-grade black powder-coat finish on the outside tube with zinc finish inner
tube and foot.
Item#
Type
Clearance
Range
Lift Capacity
44069
Top-Wind
4in.
11.25in.–21.25in.
2000 lbs.
44070
Side-Wind
6in.
11.25in.–21.25in.
2000 lbs.
GENERAL SAFETY RULES
WARNING
 Read and understand all instructions. Failure to follow all instructions listed below may result in
serious injury.
 Owner must ensure that the jack is installed according to these instructions
 Never position any part of body under this product or supported load.
 Fully retract/rotate jack before towing.
 This jack is not intended for use as a transport device. Minimize movement of the implement
while the jack is under load.
 Do not allow children to play on or around this jack while supporting a load.
 Secure the load, vehicle and trailer form rolling when operating jack.
 Never attempt to lift or support loads in excess of the rated strength of this trailer jack.
 This jack is designed for vertical loading. Excessive side forces may cause failure and or injury.
 Before moving trailer crank jack to its lowest position.
 These jacks are not designed for round tongues.