Product Manual

Page 8 of 13
Check the safety devices and the safe condition of the product.
 Check for visible defects.
 Check that all parts of the product are firmly attached.
 Check that the safety devices are in working order.
Operating Instructions
⚠WARNING
 The handle and nut must be tightened against the drive shaft before operating the winch.
 The wire rope must be properly wrapped on the drum to be able to support a load without
damaging the wire rope.
Moving or Tensioning Loads
Winding/unwinding the cable without load
1. Place the ratchet lever in the center position.
2. The cable reel now moves freely in both directions.
3. Pull the steel cable at the fixed hook until the hook can be attached to the load to be moved.
4. Wind back the excessive cable by turning the crank clockwise.
Winding up the cable under load (towing, loading)
1. Hold the crank firmly and push gently to relieve the ratchet lever
2. Place the ratchet lever at position.
3. Turn the crank clockwise to evenly wind up the steel cable.
Unwinding the cable under load (lowering, unloading)
1. To shake the handle in clockwise and anti-clockwise direction, the gear will turn in same direction
and create tractive force.
2. The steel cable should be fully retracted again after use.
After Each Use
 Wipe external surfaces of the winch with a clean cloth.
 Periodically, lubricate the wire rope with light oil. Lubricate the gear with gear grease.
Maintenance
 This winch has been fully lubricated at the factory; but, for continued smooth performance and
increased life, occasional greasing of gears and reel shaft and an occasional drop of oil on drive
shaft bearings are recommended.
 Inspect periodically all parts, steel cable, accessories and replace them if damaged or used.
 Have damaged parts replaced by an authorized service center.
 Check the nuts periodically and tighten them if they are loose.