Product Manual

5
Figure 3-3
STEP 4
Connect the light wire to the Axle Assembly (Part# A9) as below. See figure 4-1.
Figure 4-1
NOTE: The colors of the light wire through the Axle Assembly should match with those through
the Fenders. Light wires of Yellow-Brown-White are to Right Fender (Part# A7), while light wires
of Green-Brown-White are to Left Fender (Part# A8).
STEP 5
Install the Tires (Part# A15) to the Axle Assembly (Part# A9). Slide the wheel over the Hub Studs, then
use M12*1.25 Lug Nuts (Part# A17) to attach the tire/wheel assemblies. Tighten lug nuts to 85–90 ft.-lbs.
of torque. See figure 5-1.
The degree of angle between Axle
Assembly and Rear Frame is 45°.