Product Manual

Page 4 of 8
Always check damaged or worn out parts before using the lightbar. Broken parts
will affect the lightbar operation. Replace or repair damaged or worn parts
immediately.
INSTALL THE LIGHTBAR
Magnetic mounting
1. The magnetic lightbar should be positioned on the vehicles roof where the magnets will
safely secure the lightbar. Before mounting the lightbar to the roof, be sure the surface is
clean and clear of dirt, grease and debris.
2. Locate the desired location where you wish to mount the lightbar. For best results you
should make sure the lens is unobstructed, so that the light can be seen 360 degrees.
3. If you need to move the lightbar, hold one side securely, then lift the other side of the
lightbar from the room and move; repeat procedure to move the other side.
Permanent mounting
1. Turn the lightbar upside down, and then take off the rubber boots. Remove the M5x20
bolts (6) and lock nuts (3), which are in the center of magnetic bases. The magnetic base
(5), spring (4) should be pulled away from the mounting bracket. (See Figure 1)
2. Drill a mounting hole for M5x25 Hex bolt (7) on the mounting surface. Insert M5x25 Hex
bolt (7) to the mounting surface, mounting bracket, flat washer (8). Then tighten the M5
lock nut (9). (See Figure 2)