Product Manual

Page 9 of 14
Step 4 - Refer to Fig. 4 and Fig. 5
(Do this for one cross bar.) Slide a M10*20 Square-head Bolt (C) into the slot of the Cross Bar (4),
slide a Rubber V Pad Assembly (8 and 9) onto the end of the Cross Bar, slide another M10*20
Square-head Bolt (C) into the slot of the cross bar, position the M10*20 Square-head Bolts (C) in the
notches of the Rubber V Pad Assembly (8 and 9), and secure with Bolt Set C. Repeat this for the
other end of the Cross Bar (4).
(Do this for the two remaining cross bars). Slide four M10*20 Square-head Bolt (C) into the slot of
Cross Bar (4) and position them near the center of the Cross Bar (4). These bolts will be used to
attach Post A (1) and Post B (2). Slide another M10*20 Square-head Bolt (C) into the slot at each end
of the Cross Bar (4), slide a Rubber V Pad Assembly (8 and 9) onto each end of the Cross Bar, slide
another M10*20 Square-head Bolt (C) into the slot at each end of the cross bar, position the M10*20
Square-head Bolts (C) in the notches of the Rubber V Pad Assembly (8 and 9), and secure with Bolt
Set C.