Product Manual

Page 7 of 14
Assembly
In order to properly assemble the rack you first need to determine if the rack will be installed on a
LONG BED or SHORT BED truck. IMPORTANT: DO NOT tighten any bolts during the following
steps.
Recommended Tools for Assembly
Step 1 - Refer to Fig. 1
Slide two Half Supporting Frames (3) together and connect them with a Connecting Plate (6) using 8
lock washers and 8 bolts from Bolt Set A. Repeat for the remaining two Half Supporting Frames (3).
Step 2 - Refer to Fig. 2
Insert M8*25 bolts into the two holes on each of three Connecting Clamps (11).
Open Wrench
Size=10mm
Open Wrench
Size=13mm
Open Wrench
Size=17mm
Open Wrench
Size=18mm