Product Manual

UNHITCHING THE CAR DOLLY FROM THE TOW VEHICLE
1. Disconnect the Tail Light Wiring Assembly from the towing vehicle’s 12 Volt DC system.
2. Unhook the Safety Chains (B19) from the towing vehicle. Wrap the Safety Chains (B19) and the excess wiring from the Tail
Lights around the Tow Bar (A2) to keep it secure and out of the way.
3. Pull up on the Trigger and lift up on the Handle.
4. With assistance, lift the Hitch Coupler (A1) off the 2in. ball hitch and back the Car Dolly away from the tow vehicle about two
feet. Set it carefully on the ground.
INSPECTION AND MAINTENANCE
WARNING: All maintenance, service or repairs listed in this manual are only to be attempted by a qualified service
technician.
• Maintain this Car Dolly with care. Keep this product clean and dry for better and safer performance.
• Service on this Car Dolly must be performed only by qualified repair personnel. Service or maintenance performed by
unqualified personnel could result in a risk or injury.
• When servicing this Car Dolly, use only genuine replacement parts. Follow instructions in this manual. Use of unauthorized parts
or failure to follow maintenance instructions may create a risk of personal injury.
The following Maintenance Chart is a basic guideline for scheduling your Car Dolly maintenance. It may be different based on
your local conditions.
MAINTENANCE CHART
HUB BEARING MAINTENANCE
WARNING: If the following procedure is not followed, it may result in wheel locking and tire blowout, causing an
automobile accident or road hazard.
1. Whenever a Hub (A10) on a new unit requires assembly (or a Hub is disassembled for maintenance), the following procedures
MUST be followed.
2. Using a suitable solvent, thoroughly clean the Bearings (B3), Dust Cap (B6), and the rest of the parts of the Hub assembly of all
grease, dirt, metal shavings, or any other foreign objects. The parts must be cleaned even if they are new or clean.
3. Allow all parts to dry completely.
4. Clean your hands and the bearing packer (not included).
5. Place fresh, clean bearing grease in the bearing packer.
6. With the grease-filled bearing packer in one hand and the Bearing (B3) in the other, press the Bearing into the grease, forcing
the grease inside the slots in the Bearing. Continue doing this until every slot in the Bearing is completely full of grease.
7. As you finish assembling the Hub, be careful not to get any dirt or debris on any part of the assembly.
8. Replace the Dust Cap (B6) over each Bearing (B3).
CAR DOLLY
OWNER’S MANUAL
6 of 7
●
Hitch Coupler
Ensure Proper Fit
Lubrication
Wheels and Hubs
Lug nut tightness
Grease Bearings
Repack Bearings
Tires
Pressure (65 PSI) and Visual Inspection
Tread Depth
Electrical
Tail and Brake Light Operation
Electrical Ground Wiring
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
●
Maintenance Part Before Use
Before Long
Storage
After Long
Storage
After First
50 Miles
Every Year
Every
3 Months