Product Manual

9. Install the Tongue Side Brace (A8) by M12*115 Hex Bolt (B12) 11. Install the Fenders (A6 right & A7 left) on to the axle
with φ12 Flat washer (B15) and M12 Lock Nuts (B16) on assembly with ø12 flat washer (B15) and M12 lock
Tongue, then by M12*30 Hex Bolt (B9) with φ12 Flat washer nuts (B16).
10. Install the Top Panel (A5) over Ramps (A4) and Axle 12. Connect Wiring harness from Fenders to Axle assembly
Assembly. Secure with 1in.*135 hex bolt (B8) with wire harness.
ø12 flat washer (B15) and M12 lock nuts (B16).
(B15) and M12 Lock Nuts (B16) on axle.
OPERATING INSTRUCTIONS
HITCHING THE CAR DOLLY TO THE TOW VEHICLE
1. Only use a 2in. ball hitch (not included) on the towing vehicle.
WARNING: To reduce friction between the hitch ball (not included) and the Hitch Coupler (47), apply a layer of heavy
weight grease over the hitch ball (not included).
2. Pull up on the Trigger and lift up on the Handle to open Hitch Coupler (A1).
3. With assistance, place the Hitch Coupler (A1) over the vehicle’s hitch ball and push down on the Handle until the Trigger locks
in the slot. Pull up and down on the Coupler to make sure the hitch ball is snug in the Coupler. There should be no play
between the hitch ball and Hitch Coupler (A1). Tighten the Adjustment Nut until no play is present. If the Adjustment Nut is too
tight, the Handle will not lock. Once the Hitch Coupler (A1) is snug, secure with safety bolt, lock to lock coupler.
WARNING: If the Hitch Coupler is not secured properly, it could come loose while the Trailer is in motion, causing
property damage, SERIOUS PERSONAL INJURY AND/OR DEATH.
4. Attach each of the safety chains (B19) to the towing vehicle’s hitch.
WARNING: If the safety chain (B19) is too long, twist it to take up slack.
5. Connect the Tail Light Wiring Assembly to the towing vehicle’s 12 Volt DC system.
CAR DOLLY
OWNER’S MANUAL
4 of 7