Product Manual

Page 12 of 28
5. Place tires (5) onto the hubs (4) at the end of the axle. Lock tires into place using the lug nuts
(38).
Note: Use two jack stands (not included) to support the axle while the tires are being attached.
6. Connect the drawbar (6) with bolt (26) and lock nuts (34) to the center cross member of the trailer
body, and attach the drawbar to the first cross member of the trailer body with U bolts (37) and
lock nuts (34).
7. With assistance, turn the trailer over so that axle is under trailer body. Block both tires in front and
back.
8. Once the trailer is in the correct upright position, use the bolts (23), lock nuts (32), and washer
(30) to mount the fenders (13) to the tabs that extend out in behind the tires. See Figure E.